You are here:Home > Feed Rollers > Original Weinig > Steel-Knurled Rollers
An alternative to the tooth-feed rollers are the steel knurled rollers.  These rollers are primarily designed for use when only scant material is being removed from the top surface of the work piece.  The teeth on the contact surface are small diamond points, with a maximum "tooth mark" indention of less than 1mm (1/32") deep.  As with the tooth-feed rollers, the contact surface of this roller is also covered with a layer of hard chrome.
Sort By:
Page of 1
WEI-143-618003 WEI-143-618004 WEI-143-618005
Part#: WEI-143-618003; 5-1/2in OD x 3/4in wide roller for 35mm keyed shaft with extended hub Part#: WEI-143-618004; 5-1/2in OD x 5/8in wide roller for 35mm keyed shaft with extended hub Part#: WEI-143-618005; 5-1/2in OD x 2in wide roller for 35mm keyed shaft
WEI-K27-555014 WEI-K27555015
Part#: WEI-K27-555014; 5-1/2in OD x 5/8in wide cup (bolt-on) roller for 30MM shaft Part#: WEI-K27-555015; 5-1/2in OD x 3/4in wide cup (bolt-on) roller for 30MM shaft